About us
A precision machining shop built around engineers, measurement and repeatability.
Equipment overview
How we work
We are a contract manufacturer of precision-machined components. That sentence does a lot of work: it means we do not sell a catalogue, we make what your drawing specifies, and the drawing is the contract.
Most of our customers are engineering teams — design engineers, buyers and quality managers who have a print, a deadline and a tolerance they cannot compromise on. What they usually want from a supplier is not the lowest price on a spreadsheet, but a predictable one: parts that measure right, arrive when promised, and come with the paperwork their own quality system demands.
What we chose to invest in
Three things, in this order.
People who can read a drawing. Every quotation is reviewed by a manufacturing engineer before it reaches you. That costs us margin on small enquiries, and it is the reason our first-article rejection rate stays low: problems get found at the quotation stage, not on the shop floor.
Measurement. A temperature-controlled metrology room with three bridge CMMs is an expensive thing for a shop our size. It exists because a tolerance you cannot verify is a tolerance you do not actually hold.
Process capability rather than machine count. We would rather run fifty machines properly maintained, calibrated and documented than eighty that are merely busy.
Where we are going
Every job carries its own inspection record: what was measured, on which equipment, by whom, and against which drawing revision. Lots stay segregated, drawing revisions are controlled, and first article results are documented before a batch is released.
We would rather show you an inspection report you can check than a wall of logos.
Working with us
You will deal with an engineer, not a chatbot. Quotations come back within a working day with a note on manufacturability. Drawings stay confidential, NDAs are signed before file exchange if you want one, and tooling you pay for belongs to you.
If we cannot make your part to the tolerance you need, we will tell you that too — and, where we can, suggest who can.
What we stand for
Engineer-reviewed quotations
Each RFQ is checked by a manufacturing engineer for tolerance stack-up, wall thickness, tool access and cost drivers. You receive a DFM note, not just a price.
Documented and traceable
Material certificates (EN 10204 3.1), dimensional reports, RoHS and REACH declarations. Every lot is traceable to raw material and operator.
Confidentiality by default
Drawings are stored on access-controlled servers, never shared with third parties, and mutual NDAs are signed before file transfer on request.
One supplier, full process chain
Machining, heat treatment, surface finishing, laser marking and assembly are coordinated by us. Fewer interfaces, fewer delays, one responsible party.
Equipment overview
Send us your drawing today
STEP, IGES, X_T, DWG, DXF, PDF or STL. Every file is treated as confidential and covered by NDA on request.